How to use the SMT air shower chamber

2022-07-25 45

Product management SMT workshop air shower room one, panel schematic diagram and operation instructions: wind shower panel schematic diagram and operation instructions emergency stop button: press the emergency stop button at any time, blue backlit LCD screen emergency stop graphic flash, when pressed again, the system returns to the initial state.

 This button is mainly used when the inner and outer doors cannot be unlocked. Wind shower button: that is, manually switch the wind shower lighting button: that is, manually switch the lighting up and down buttons: before or after the start or end of the wind shower, adjust the wind shower delay time by adjusting the wind shower key. Second, the correct use of the process 1, into the SMT air shower room - clean area process: 1. Personnel entering the clean clean room should wear clean dust-free clothes, hats, shoes and masks in the outer locker room; Confirm that the green light is lit before opening the door.2.Open the front door of the air shower room into the air shower room to carry out blowing and dust removal (must be in the case of no one in the air shower room).3.Close the air shower door, the infrared human body heat sensor senses the human body after the air shower system automatically starts to blow.4.The blowing process will stand the body in the central position as much as possible and turn 360 °.5.After the blowing, it should enter the clean room from the back door (that is, the dust-free indoor door). Enter the SMT air shower room clean area process 1 Enter the SMT air shower room clean area process 2 Enter the SMT air shower room clean area process 32, leave the clean area: 1. First make sure that the green light is on, open the inner door 2. The outer door is electrically locked.3.After the inner door is completely closed.4.Open the outer door, leave the clean area Process 1 Leave the clean area Process 23, Note 1, without the permission of the Equipment Section, no one should modify the parameters; 2, non-emergency situation, no one should touch the controller button at will; 3, when the control system fails, you can press the emergency stop button to lift the fault, and timely report to the equipment department for maintenance. 4, the green light is lit to pass; The red light is on and it is forbidden to turn on!